Plastic clamp lever with flat washer for slotted holes.
The projection on the washer seating surface prevents the washer from turning and the pointer on the top always points to the scale, making it suitable for a slide mechanism that uses slotted holes.
Washers are built into the relief cut section to prevent them from falling off. This also eliminates the need to mount washers.
The outside diameter of the washer is about 3 times the screw diameter. This provides a sufficient seating surface for the tightening area.
The zinc die cast serration ring is inserted into the plastic lever main unit. It achieves sufficient fitting strength with the metal screw serrations.
The lever is available in 3 color variations. They can be selected by the end symbol of the part number.
End Symbol
Lever Part Color
BK
Matte Black
SG
Matte Silver
OR
Matte Orange
Only takes a minute to understand! How to Use Clamp Levers.
Precautions for Use
Refer to the washer index as a guide.
Before tightening the lever, make sure that the washers are located at the relief cut section as shown in Fig. 1. Tightening the washer while hooked on the screw thread as shown in Fig. 2 may cause the washer to be deformed.
Related Products
Standard plastic clamp lever LEMS is available. LEMS
※Selection condition can be saved where Product Finder is available.
※Please remain the function of cookies for the browser and the JavaScript in effect when using this function.
Please correct the error in selection condition.
Please specify at least one select criterion.
Your request has been cancelled due to the duplicated page.