Date Published:Oct. 13. 2021
For better drive
For better drive
Select an appropriate Couplicon according to the following procedures.
1. Type selection
By referring to Couplicon selected from the table, Couplicon selected based on motor, and Couplicon selected based on application , select the most appropriate Couplicon type.
2. Size selection
Select a size such that the normal torque is greater than the load torque generated during continuous system operation.
Note that the normal torque value allows for load fluctuations during operation, so rated torque compensation is not required when making a selection (excluding Oldham types).
3. Torque correction by operating temperature
For rubber/resin-material Couplicon, the rated torque and max. torque vary depending on the operating temperature.
If ambient temperature exceeds 30°C, be sure to correct the rated torque and max. torque with temperature correction factor shown in the following table.
|Ambient temperature||Temperature correction factor|
|−20℃ - 30℃
|30℃ - 40℃||0.80
|40℃ - 60℃||0.70
|60℃ - 120℃||0.55
In other Couplicons, the rated torque and max. torque do not vary depending on the operating temperature. Correction by temperature correction factor is not required.
4. Checking of max. bore diameter and max. rotational frequency
Ensure that both of the max. bore diameter and max. rotational frequency exceed the bore diameter and rotational frequency specified in the design conditions.
If either or both of the max. bore diameter and max. rotational frequency are not satisfied, change the size.
Finally, ensure that other items also satisfy the design condition by referring to the Dimention/Performance table.
Recommended Articles for You
High-Gain Rubber Type Coupling XG2
This suppresses servo motor hunting and greatly shortens settling time. New NBK coupling XG2. Exhibits even higher responsivity than metal disk couplings. Contributes to improving productivity, such as suppressing speed unevenness during stepper motor operation.
Screws must be protected from chemicals 【Energy-saving / reduced work-hours】
Introducing screws with excellent chemical resistance and screws with head coatings.
Improved reproducibility of the main column / reference position is required 【High rigidity / high accuracy】
Introducing case studies in which variability of the spring constant is suppresses to improve reproducibility of the main column/reference position.